Please contact us through live-chat, email, or phone to check inventory and current lead-times.Īll our products are shipped through LTL Freight carriers. However, if they are not in stock, then our lead-times are normally 1-4 weeks from order date. We do our best to have as much inventory as possible. These instructions are useful for all fenders sold by Advanced Fiberglass Concepts.-therefore some of the steps may not be needed or should be slightly altered to suit your particular vehicle and product needs.
#White cateye chevy free
If you need further assistance with this installation, feel free to call us-one of our techs will be more than happy to help you. Not all trucks are the same so you may need to remove the grill and lights on some models. Therefore, please be patient when you start this job. Please keep in mind, although all of our products are made from factory steel fenders, hoods, and bedsides, there is a difference in fit because of the thickness of the fiberglass compared to steel. If the hood sits too low or too high, you can adjust it by turning up or down the rubber height adjuster at the front of the hood located in the core support, or hood. This is because fiberglass fenders are thicker than steel. You may need to sand some of the fender down so it does not stick out too far from the rest of the body. You will need to be patient to get a good fit. Do not over tighten! The fiberglass fender will make sounds like it is cracking-this is common as it is fiberglass, so do not worry. Once you have the gaps spaced, tighten down the bolts. We recommend using a mixing stick to get the same gap at the door and hood area. Step 6: Reinstall fiberglass fender and begin to bolt it down- but do not tighten all the bolts until you have the right gap. To get a consistent hood and door gap, use a mixing stick between door and fender. Step 5: Drill holes out with a 3/8 drill bit-the reason for this is so you can move the fender back and forth to align the gap in the hood and door area. (Note: Most fenders have markings where to drill, but some do not) Step 4: Set fiberglass fender in its place and mark the holes that need to be drilled. Step 3: Remove steel fender by skinning the exterior fender from the inner shell from truck once all the bolts have been removed. Step 2: Remove plastic liner from fender, marker lights, and headlights. (Note: not all trucks have bolts located in all the areas mentioned above) Step 1: Open hood and remove bolts holding the fender down under the hood, behind the doors, under the door areas, and behind the bumper. Metal Shears or Sawzall or Plasma Cutter.
#White cateye chevy drivers
#White cateye chevy install
Advanced Fiberglass Concepts LLC does recommend that a professional install for a seamless fit install these products. Also, you will reuse most of your stock hardware during this installation-it is typical to have a few screws and bolts left over, however. You will need a few hand tools and a few hours of time, depending on the products you have purchased. All of our products are fairly easy to install.
0 kommentar(er)
